Weboldalunk használatával jóváhagyja a cookie-k használatát a Cookie-kkal kapcsolatos irányelv értelmében. Elfogadom
Termékek Menü

SAPHO ISOLA szigetelő lemezek, 60x120cm, 6mm (6x = 4,32m2)

Ár:
47.490 Ft (37.394 Ft + ÁFA)
Cikkszám: 06 WTZ606
Gyártó: Sapho
Menny.:db

Paraméterek

Garancia 2 év
Márkanév: Sapho
Széria TEPLÁ DLAŽBA- WARM TILES
Súlya: 13 kg

Leírás


Insulation for heating systems WARM TILES under floor tiles - 6 mm

Bulk density: 32 kg / m thermal conductivity coefficient: 0.027 W / mK.

The warming of the pavement with the heating mat can take about 45 - 60 minutes in the standard construction (base concrete, thermal insulation 6cm, concrete slab 5cm, WARM TILES mat , adhesive cement, tiles). For floors without thermal insulation, this heating may take longer . If underfloor heating is only used as a comfortable floor heating in short intervals (eg about 1 am in the morning and evening), we recommend applying ISOLA- BOARD insulation to greatly reduce the floor heating time.

Procedure:
Absorb the substrate (concrete)
Fasten the sealant with ISOLA- Board insulation.
After hardening (approx. 24 hours), we apply the WARM TILES heating element and align it with a flexible sealant (care is taken to ensure that the heating cable is completely covered by the sealant).
After hardening, we tile the pavement. Track height (incl. Pavement) 2.5-3cm.

Heating mats and Warm Tiles with increased protection in damp areas increase comfort when using the bathroom, toilet or kitchen. Using the wall thermostat, the desired floor temperature and switching time can be selected. The floor can be warm only in the morning and in the evening when you use the bathroom most often. The installation itself during the laying of the tiles is not complicated and certainly worthwhile. The warm floor will enjoy bare feet not only in the winter months.

Advantages:

  • minimum mounting height 3-5 mm
  • mounting directly under the tile into a flexible adhesive
  • suitable for any substrate, it can also be used for existing paving during the reconstruction
  • faster heating up than conventional systems
  • Easy and fast installation during laying of tiles
  • possibility to use as year-round or additional heating
  • the possibility of heating selected areas or whole areas
  • simple operation with a wall thermostat
  • the goods are produced in the Czech Republic

More information:
Resistor cables are the most common type of heating cables. The core of these cables is the so-called resistance (resistive material) that is heated when the electric current passes.

The underside of the mat is fitted with a double-sided adhesive tape, allowing the mat to be fixed to the substrate rather than overlaid with flexible cement.

The heating mat is actually a heating circuit that is fixed in the fabric to loops with uniform spacing. The laying mat is considerably easier than for the heating cable, even distribution of the flat power is ensured.

Two-core heating cable - the connection wire is only at one end of the heating cable. When installing, it is not necessary to return with the cable back to the connection point.

The mat should not be placed under the furnishings such as bathtubs, showers, toilets, etc., as well as furniture that does not allow free air flow. Minimum spacing of heating cables from fittings (bathtub, shower, built-in wardrobe, kitchen ...) to prevent heat removal and the walls are 5 cm.

Installation and connection of two heating mats is possible. Linking is the mind of el. the mats are connected in parallel to the thermostat output - both mats are switched simultaneously. Connection of one mat on the other end is not possible.

By not using a sufficient layer of thermal insulation under the heating system, you are exposed to the risk of heat loss down into the floor. For optimal operating parameters, we recommend using our special ISOLA insulating washers.

How fast can you expect heating up? With additional isolation ISOLA approx. 10-15 minutes * ) , without additional insulation (according to floor composition) 1-3 hours, in extreme cases (floor without thermal insulation) the system can be practically inoperative.


* ) Increase of floor surface temperature from 20 ° C to approx. 27 ° C at air temperature 20-22 ° C.

Hasonló termékek

Cikkszám: 06 PASAND55
47.490 Ft
Cikkszám: 06 X000001072
46.645 Ft
Cikkszám: 06 X000001070
46.645 Ft
Cikkszám: 06 X000001075
46.645 Ft
Cikkszám: 06 X000001073
46.645 Ft
Cikkszám: 06 X000001079
48.925 Ft
Cikkszám: 06 X000001078
48.925 Ft
Cikkszám: 06 X000001076
48.925 Ft
Cikkszám: 06 X000001081
48.925 Ft
Cikkszám: 06 P04763
45.590 Ft
Cikkszám: 06 164974
49.391 Ft